MEDIA CENTER
May 22th, 2025
How to assemble the ZIP fabric blinds?
Check all the components according to the packing list.

- Top housing
- Front housing
- Bottom housing
- Guide strip
- End Seat
- End seat decorative cover
- Slots
- Pins
- Lower cowling mounts
- Positioner plate
- Rotating disk
- Motor plug-in
- Terminal Block
- Axle head
- Tail plug
- Tail Plug Inserts
- Drive shaft
- Bottom beam C
- Composite Seal
- Counterweights
- Bottom beam plug C
- Motor model (for demo)
- Guide rail seat
- Guide rail cover
- Guide rail seal
- Elastic guides
- Zip slides B
- Screws
- Power holder shell
- Fabric
Install End seat & Positioner Plate

Place the positioner plate and slots onto the end seat,
and use hexagon socket countersunk head screws M4x10
to fix them together
Install End seat & Top housing

The outlet hole is on the right.
so fix the power holder shell on the right end seat.
Pass the wire through the outlet.
Attach right end seat to the top housing,
and attach left end seat to the top housing as well.
Fix them with countersunk head screws M4x20.
Install Front housing & Top housing

Attach the front housing to the top housing
Use Phillips countersunk head tapping screws M4x20
to fix the front housing and the end seat.
Fix the front housing to the upper housing
with Phillips pan head tapping screws ST4.2×8.
Fix the front housing to the end capsules
with Phillips pan head tapping screws ST3.5×13.
Install End seat decorative cover

Attach the front housing to the top housing
Use Phillips countersunk head tapping screws M4x20
to fix the front housing and the end seat.
Fix the front housing to the upper housing
with Phillips pan head tapping screws ST4.2×8.
Fix the front housing to the end capsules
with Phillips pan head tapping screws ST3.5×13.
Install Drive part

Fixing the rotating disk
with Phillips pan head tapping screws M4x16
And use Phillips countersunk head tapping screws M5x16
to fix Motor plug-in.
Scenario of connecting terminals
Motor model (without terminals)

Put the motor, tail plug, rotating disk together

Connect the motor to the drive shaft.
Install Bottom beam

Insert the zip into the bottom beam
Pull the fabric out a little
Insert the bottom beam plug
Fix the bottom beam plug
with Phillips countersunk head tapping screws M3.5×13.
Phillips countersunk head tapping screws ST2.9×9.5
Insert the counterweight
Insert the bottom beam plug
Insert the composite seal
Fixing the bottom beam plug
with Phillips countersunk head tapping screws M3.5×13
Connect the top of the fabric to the drive shaft
Insert the drive section into the slots,
and use hexagon socket head cap screws M4x12
to fix them together.
Fix the guide strip
Snap fasteners need to be inserted into the grooves
Attach the lower cowling mounts
with socket head cap screws M4x12
Attach the lower housing to the front housing,
and fix them with hexagon socket countersunk head screws M4x10
Install Guide rails

Insert the guide rail seal into the rail seat
with hexagon socket head cap screws M5x6.
Fix the rail cover and rail seat
with Phillips pan head tapping screws ST4.2×8.
The chamfered end of the Zip slides is the top
Press the Zip slides into the rail

Contact us

Kevin
Account Manager

info@ulepanda.com

+86 18551587339

+86 18551587339